Level measurement in a recycled sludge tank

Application Note | Water & Wastewater

  • Collecting sludge from septic systems at waste water plant
  • 3,65 m / 12 ft deep underground tank with moving medium
  • Pump control for the distribution of sludge to further treatment

Achtergrond

In the United States, many suburban and rural homes are still equipped with septic tank systems. Domestic wastewater is disposed of through these systems which also perform a degree of on-site waste treatment. However, the residual waste has to be periodically removed from these systems and transported to a waste water treatment plant by septic tank cleaning services (so called Honey Dippers).

An American waste water treatment plant operator in suburban Philadelphia, PA, collects the septic tank waste in a recycled sludge tank. From there it is routed via the main plant influent line to different sludge treatment systems for aerobic digestion, dewatering, lime stabilisation, thermal drying or incineration.

Meetvereisten

The sludge from the 3.65 m / 12 ft. deep and 1,8 m / 6 ft. wide underground tank is emptied by pumps and distributed to the different plant treatment systems via influent pipelines. The sludge level has to be continuously measured in order to control the pumps and to avoid drying up or overfilling of the tank. The customer had previously used a submersible pressure transducer to ensure a correct start or stop of the pump. However, the device failed to produce stable measuring results due to the constantly moving medium. The customer hence considered the installation of a more reliable technology.

KROHNE oplossing

KROHNE fitted an OPTIFLEX 1100 C with single cable probe (Ø2 mm / 0.08") and a threaded ¾ NPT process connection on top of the tank.

The treatment plant’s service technicians easily assembled the OPTIFLEX 1100 C probe by themselves, attached it to the threaded connection and screwed it directly into the metal plate that covers the sludge tank. They ran a quick set-up via the local display and the sensor adjustment was performed at 3.65 m / 12 ft.

The OPTIFLEX 1100 C level meter uses the Time Domain Reflectometry (TDR) technology. It transmits low-intensity electromagnetic pulses along the conductor in the cable probe. When the pulses reach the surface of the sludge, some of the pulse energy is reflected back to the signal converter. The time from when the pulse is transmitted to when it is received is measured by the instrument. The time value is then converted into a 4 to 20 mA analog output current equivalent to the level. This signal is sent to the plant PLC for process control and monitoring.

Voordelen voor de klant

Since the measurement is unaffected by the moving medium as well as physical property variations such as density, the OPTIFLEX 1100 C is a preferred alternative to the pressure transmitter. It is an affordable device for this application that does not necessarily require an extremely high level of accuracy. The customer benefits from a continuous and reliable level measurement of the recycled sludge.

Thanks to the level meter, the pumps can now be effectively controlled and helps prevent serious damage to the pumps from the tank drying up. Even with a ladder or other metal parts installed inside the tank, the performance of the OPTIFLEX remains stable. Other leakage problems were also avoided from the start since the level meter was tank top mounted and the quick installation was another advantage to the customer.

Toegepaste instrumentatie

OPTIFLEX 1100

Guided radar (TDR) level transmitter for basic liquid applications

  • Continuous level measurement in buffer, storage, collecting or recycling tanks
  • Intuitive quick setup procedure
  • Measuring range: 0.7…20 m / 2.3...65.5 ft
  • -50…+100°C / -58…+212°F; -1…16 barg / -14.5…232 psig
Email
Contact